THOMSON MEC 320 - GENSET CONTROLLER User Manual

MEC 320 GENSET CONTROLLER
PM079 Rev 0 07/06/08 49 Thomson Technology
Parameter access
To get access to adjust the parameters, the password level must be entered:
If the password level is not entered, it is not possible to enter the parameters.
The customer password can be changed in menu 9116 page 115.
The service password can be changed in menu 9117 page 115.
The master password can be changed in menu 9118 page
115
.
The factory passwords must be changed, if the operator of the gen-
set is not
allowed to change the parameters.
It is not possible to change the password at a higher level than the password
entered.

THOMSON MEC 320 - GENSET CONTROLLER Specifications

General

Brand	THOMSON
Model	MEC 320 - GENSET CONTROLLER
Category	Controller
Language	English