THORLABS PM100 - 7 Listings; Default Settings

7.1 Default Settings
PM100 / page 49
7 Listings
7.1 Default Settings
The PM100 measurement system comes with the following factory settings:
Setting Default
Autorange Enabled
Analog Output 0.1V/mW
Display Refresh Rate 3/s
Shutdown 10 minutes
Backlight 5 seconds
Contrast 72%
Line Filter 50Hz
Wavelength Correction Silicon Sensors:
1: 635nm; 2: 670nm; 3: 780nm; 4: 830nm; 5: 980nm
Germanium Sensors:
1: 780nm; 2: 830nm; 3; 980nm; 4: 1310nm; 5: 1550nm
User Calibration 0.00 dB
Dark Current Adj. /
Zeroing
0 A; 0 V
Baudrate 115200 Baud