Toa RM-200M - Summary of Emergency Broadcast Procedures

30
Microphone announcement
Press either the All-Zone Call key or Output key to select the output zone.
(If the zone is not selected, emergency broadcasts are made over all zones.)
To terminate the emergency broadcast, reset the emergency mode using one of the following methods:
•
Press the Reset key on the front panel of the VM-3240VA.
•
Input a reset signal to the Emergency Control Input terminals on the rear panel of the VM-3240VA or VM-3240E
which has been assigned a reset function.
Press the Emergency Activation switch.
Normal status
Automatic emergency announcement
6.2. Summary of Emergency Broadcast Procedures
[Making emergency broadcasts from the VM-3240VA]