A failure has occurred in communications between the unit and the VM-3240VA.
The previous status is automatically restored if communications return to normal.
9.4.1. Equipment operation upon failure detection
[VM-3240VA]
The buzzer sounds, the failure indicator flashes yellow and failure information is displayed on the LCD screen.
Equipment operation upon failure detection
In this event, a failure of the contents shown on the LCD screen has occurred within the system. Pressing the
amplifier’s [OK] key to acknowledge the failure stops the buzzer and switches the yellow failure indicator from
flashing to steady-on mode. (Refer to "Failure Acknowledgement" on page 36).
If the failure is reset at the amplifier, the failure indicator goes out. However, if the cause of the failure has not
been remedied, the unit will return to failure status. (Refer to "Failure Reset Operation" on page 37).
[VM-3240E]
The Communications Failure indicator flashes yellow.
Equipment operation upon failure detection
To Next Page
Loading...
