■
3-62
■
Data cannot be sent in some configurations if the ID number is not
entered. Refer to “3.9.1 General.”
■
It is recommended to send data after entering the ID number. The data
can be sent without ID numbers entered; however, the corresponding
patient may not be traced from the inspection file output from DATA
Transfer. When the data was sent without entering the ID number,
check the content of the inspection file immediately after sending the
data, and move and save the file in an appropriate location. In addition,
when data is sent to TOMEY Link, all data without ID numbers is
regarded as data of the same patient, so must be handled with great
care to avoid mishandling.
■
Waveforms of the same form as those to be printed out are output.
Refer to “3.8.2 Print” for details.
1) Touch the “Export” button (1) to open the Transmission confirmation screen
(Fig. 2).
(Fig. 2).
2) The transfer confirmation screen (Fig. 1) displays patient ID, patient name,
and sex. Touch the "Export" button (2) to start sending data. Touching the
"Cancel" button (3) returns you to the previous screen without sending data.
To Next Page
Loading...
Need help?
General
