Tonghui TH2827 Series - Page 18

TH2827 Series Operation Manual Chapter 3 Introduction to [MEAS]
12
Primary parameter
 |Z| (Module of impedance)
 |Y| (Module of admittance)
 L (Inductance)
 C (Capacitance)
 R (Resistance)
 G (Conductance)
 DCR (DC resistance)
 L2A (Primary inductance)
 L2B (Secondary inductance)
Secondary Parameter
 D (Dissipation factor)
 Q (Quality factor)
 R
s
(Equivalent Series Resistance ESR)
 R
p
(Equivalent Parallel Resistance)
 X (Reactance)
 B (Susceptance)
  (Phase Angle)
 N, 1/N (Turn ratio and polarity)
 M (Mutual inductance)
 R2 (DC resistance)
Test results of primary and secondary parameters are respectively displayed in
two lines in the form of upper-case characters. The primary parameter displays in
the upper line while the secondary parameter displays in the lower line.
Operation steps for setting test function:
1) Move the cursor to FUNCA
zone, the following soft keys will be displayed on
the screen.
 C
p
—…→
 C
s
—…→
 L
p
—…→
 L
s
—…→
 ↓
2) Press the soft key corresponding to C
p
—…→, the following parameters will be
shown for your choice.
 C
p
-D
 C
p
-Q
 C
p
-G
 C
p
-R
p
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.