Tonghui TH2827 Series - Page 20

TH2827 Series Operation Manual Chapter 3 Introduction to [MEAS]
14
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
9) Press R—…→, the following parameters will be shown for your choice.
 R-X
 Rp-Q
 Rs-Q
 ←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
10) Press ↓, the following parameters will be shown for your choice.
 G-B
 DCR
 L2A—…→
 L2B —…→
 ↑
11) Press G-B, choose the desired parameter.
12) Press DCR, choose the desired parameter.
13) Press L2A-…→, the following parameters will be shown for your choice.
 L2A-N
 L2A-1/N
 L2A-M
 L2A-R2
←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.
14) Press L2B-…→, the following parameters will be shown for your choice.
 L2B-N
 L2A-1/N
 L2B-M
 L2B-R2
←
Press the soft key corresponding to your desired parameter. Then press ← to
return to upper soft key menu.