Tonghui TH2827 Series - Page 95

TH2827 Series Operation Manual Chapter 7 Command Reference
89
Character 0 (48) is equal to OFF.
For example: WrtCmd (“FUNC:IMP:RANG:AUTO ON”) Set the automatic range
as ON.
Query syntax: FUNCtion:IMPedance:RANGe:AUTO?
Return format: <NR1><NL^END>
The FUNCtion:Source MONitor:VAC command is used to set the voltage monitor
ON or OFF. The FUNCTtion:Source MONitor:VAC? query returns the current
voltage monitor status.
ON (1)
FUNCtion:SMONitor:VAC OFF (0)
Where,
Character 1 (49) is equal to ON.
Character 0 (48) is equal to OFF.
For example: WrtCmd (“FUNC:SMON:VAC ON”) Set the voltage monitor as ON.
Query syntax: FUNCtion:SMONitor:VAC?
Return format: <NR1><NL^END>
The FUNCtion:SMONitor:IAC command is used to set the current monitor as ON
or OFF. The FUNCtion:SMONitor:IAC? query returns the current monitor status.
Command syntax:
ON (1)
FUNCtion:SMONitor:IAC OFF (0)
Where,
Character 1 (49) is equal to ON.
Character 0 (48) is equal to OFF.
For example: WrtCmd (“FUNC:SMON:IAC ON”) Set the current monitor as ON.
Query syntax: FUNCtion:SMONitior:IAC?
Return format: <NR1><NL^END>
The FUNCtion:DEV<n>:MODE command is used to set the deviation
measurement mode. The FUNCtion:DEV<n>:MODE? query returns the current
deviation measurement mode.
Command syntax: