Regulatory Information
GRS-1 Operator’s Manual
C-4
European Community Declaration of
Conformity with R&TTE Directive 1999/5/EC
The following standards were applied: (R&TTE Directive 1999/5/
EEC)
• EN 301 489-1 V1.6.1 & EN 301 489-7 v1.3.1 & EN 301 489-17
V1.2.1 & EN 301 489-24 v1.4.1
• EN 300 328 V1.7.1
• EN 301 511 v9.0.2
• EN 301 908-1 & 02
• EN 50371
• IEC 60950-1 & EN 60950-1
The following CE mark is affixed to the device:
To comply with RF exposure compliance requirements, a separation
distance of at least 20 cm must be maintained between the antenna of
this device and all persons. This device must not be co-located or
operating in conjunction with any other antenna or transmitter.
Canadian Emission Labeling
Requirements
1. Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
2. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent
To Next Page
Loading...
Need help?
General
