Topcon HiPer V - Charging the Batteries

Managing Power
Batteries
31
P/N:1001608‐01
Charging the Batteries
Whenthebatterychargeislow,theAvailablePowerBarchangesfromsolidgreentoyellowtoredandthenblinking red,
dependingontheremainingcharge(see“AvailablePowerBar”onpage 20).Whenthereceiverisconnectedtoanexternal
powersource,thebatterydoesnotchargeandbecomesdisabled
fromsupplyingpowertothereceiver.
Tochargethebattery,usethesuppliedcharger.Ittakesapproximately4hourstocompletelychargeonebatteryand8
hourstocompletelychargetwobatteries.TheLi‐Ionbatteriesusedin thebatterypacksshouldrunatnolessthan80%
capacityafter500chargingcycles.Youdonotneed
todrainthebatteriesbeforerecharging.
To charge the batteries:
1. Connectthepowercabletothechargerandplugthechargerintothewalloutlet.
Thebatteriesareshippedfromthefactorywithapartialcharge.Formaximumoperatingtime,fullychargethe
batteriesbeforeusingthereceiver.