Troubleshooting
Motorgrader System Five Operator’s Manual
7-4
2. Slowly lower the right side of the blade. The slope value should
decrease smoothly and continuously. If your slope sensor is
responding this way, proceed to next step.
Figure 7-3.
Your Slope Sensor is not working properly if:
• The numbers increase or decrease erratically as the blade is
smoothly raised and lowered.
• The number displayed continues to change even though you have
stopped moving the blade.
If your Slope Sensor is responding this way, contact your local
Topcon dealer.
¥ | ¥
PASS
0
ERROR
E
NT
E
R
E
XIT
KNOB
VALUE
LASER
SONIC
KNOB
VALUE
LASER
SONIC
MAINFALL
ROTATION
SLOPE
SYSTEM TEST
¥ | ¥
PASS
ERROR
2.58
¥ | ¥
PASS
0
ERROR
2.7%
5
°
-3.7%
To Next Page
Loading...
