Sonic Stringline
P/N 7010-0344
5-5
Measure, from the bottom of the lath, the desired hike-up and
make a mark at that point. Place the Cut/Fill Decal on the lath
with "0" on the point you marked.
Figure 5-4.
5. Next, set the cut/fill lath on the hub and read the cut or fill from
the grade stake next to the hub. Adjust the clip up or down until
the stringline crosses the cut/fill lath at that point.
A cut of .25 feet
Figure 5-5.
0
1
1
SET "0" ON DECAL
AT 2.0' MARK FROM
BOTTOM OF LATH
2.0'
LATH
LATH
CUT
.25
CUT/FILL
LATH
GRADE
STAKE
.2
.1
.3
0
.
1
.
2
BLUE
=
FILL
RED
=
CUT
To Next Page
Loading...
