Torbal AD60 - Totalizing Configuration

23
Instruction Manual – AD Series
9.6 Totalizing Configuration
23
Totalizing is used to calculate the summation of multiple weights that are recorded sequentially.
1. To enable Totalizing, select “” in the Mode Menu by pressing “T” (YES) key.
2. Commands “” and “” will be displayed sequentially. To enable Totalizing, select “” with the
“T” key. To disable Totalizing, select “” with the “T” key.
3. Totalizing can operate in three different modes: Automatic (), Semi-automatic () and Manual
() (see Table 9.6). The three operating modes will display sequentially. When the desired mode is
displayed, press the “T” key to make the selection.
Example (Selecting Automatic):
4. After selecting the operating mode, “  ”  will be displayed, indicating that the function has been configured and
it is ready to use.
5. To use the function follow the directions in Chapter 21. To exit the mode menu use the “C” key.
24
Table 9.6: Totalizing Operating Modes
Automatic
Totalizing and Adding: Automatic
When set to Automatic, the scale will automatically
add the first stable weight reading to the total.
Manual
Totalizing and Adding: Manual
When set to Manual each weigh has to be manually
added to the total by pressing a designated key.




