1. Carefully remove the scale, pan, and all of its components out of the packaging. Place them on a stable surface
where the scale will not be affected by any mechanical vibrations or high air movements.
2. After removing the pan base and the pan from their packaging, carefully install the pan base (2) onto the scale by
seating it on the pan support located in the middle of the scale. Once the pan base has been installed, carefully place
the pan (1) on the base
3. Once the pan has been installed, level the scale by adjusting the front feet (6) until the level indicator (7) shows the
“air bubble” is in the center position of the sight glass. The level indicator is located on the rear left side of the scale.
To Next Page
Loading...
