Instruction Manual – AD Series
In check weighing MIN indicates that the weighing
result is below the selected under limit.
In check weighing MAX indicates that the weighing
result is above the selected over limit.
In check weighing OK indicated that the weighing
result is between the selected limits and the result is
acceptable.
In totalizing this indicator signals that the displayed
result is a total sum.
In parts count this indicator shows that the result is a
piece count
In percent weighing this indicator shows that the
result is a percentage.
Taring or re-zeroing in progress
The scale is in the calibration mode.
The scale is taring before the calibration process.
Place a calibration weight on the pan to begin calibration.
Calibration procedure is finished.
In Animal Weighing, this command represents the average weighing time.
In Parts Counting, taring a container is required before continuing the counting
transaction.
In Parts Counting, or percent weighing this command indicates to place the sample
on the pan.
In Parts Counting, this command represents the current sample size setting.
In parts counting, begin counting.
In Check Weighing, this command represents the under limit and indicates under
result.
In Check Weighing, this command represents the over limit and indicates an over
result.
In Check Weighing, this command indicates that the weighing result is within the
limit range.
In Check Weighing, tare before continuing.
In Percent Weighing, this command indicates the weight of a stored reference
weight.
In Percent Weighing, this command indicates that the scale is ready for percent
weighing based on a stored reference weight.
In Totalizing, this command indicates that a confirmation is required before the
Totals are cleared.
COUNT FINISH, TO START COUNT
PRESS C
In Parts Counting this command indicates that Parts Counting is finished.
To Next Page
Loading...
