Toro Greensmaster TriFlex 3400 - Cutting Reel Motors

Greensmaster 3300/3400Hydraulic System Page 5 -- 80
Cutting Reel Motors
1. Reel motor
2. Hose assembly
3. Hose assembly
4. Hose assembly
5. 90
o
hydraulic fitting (2 per motor)
6. O--ring
7. O--ring
8. Hydraulic fitting
9. O--ring
10. O--ring
11. Motor mount
12. Retaining ring (2 per mount)
13. O--ring
14. Cutting unit
15. Motor clamp
Figure 55
1
3
6
7
4
5
5
2
8
9
10
11
13
12
6
7
14
15
Removal (Fig. 55)
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
CAUTION
Before continuing further, read and become fa-
miliar with General Precautions for Removing
and Installing Hydraulic System Components in
this section.
2. Thoroughlycleanhydraulichoseendsandfittingson
reel motor to prevent hydraulic system contamination.
3. Label hydraulic hoses for assembly purposes.
4. Disconnect hydraulic hoses from fittings on the reel
motor. Allow hoses to drain into a suitable container.
Caporplughosesandmotorfittingstopreventcontami-
nation.
5. Remove reel motor from the cutting unit:
A. Push the motor clamp out of the slots on the mo-
tor mount toward the cutting unit sideplate (Fig. 56).
B. Slide reel motor from cutting unit (Fig. 57).
6. Remove two (2) retaining rings that secure motor
mount (item 11) to reel motor. Remove motor mount
from motor.
NOTE: Theposition ofhydraulicfittings onthereelmo-
tor is critical to properly reconnecting hydraulic hoses.