Greensmaster 3300Page 3 -- 14Gasoline Engine
Engine
Figure 9
1. Engine assembly
2. Spacer screw
3. Muffler
4. Muffler mount
5. Cap screw (4 used)
6. Flange nut (4 used)
7. Muffler shield
8. Hardened washer (8 used)
9. Cap screw (4 used)
10. Muffler clamp
11. Lock nut (4 used)
12. Pump mount
13. Cap screw (4 used)
14. Exhaust manifold
15. Gasket (2 used)
16. Flange head screw (4 used)
17. Engine frame
18. Flange head screw (3 used)
19. Square key
20. Engine hub
21. Square head screw (2 used)
22. Rubber coupling
23. Coupling spacer (2 used)
24. Flange head screw (2 used)
25. Lock washer
26. Flat washer (4 used)
1
2
3
4
5
6
7
9
10
11
12
17
13
18
19
14
21
22
23
24
15
16
8
8
25
26
20
FRONT
RIGHT
90 to 110 in--lb
(10.2 to 12.4 N--m)
Antiseize
Lubricant
25 to 38 ft--lb
(34to51N--m)
20 to 25 in--lb
(2.3 to 2.8 N--m)
170 to 200 in--lb
(19.3 to 22.6 N--m)
Engine Removal (Fig. 9)
1. Parkmachineonalevelsurface,disengageandlow-
er cutting units, move functional control lever to neutral
(N),engageparking brake,stopthe engineandremove
the key from the ignition switch. Wait for all machine
movement to stop.
CAUTION
The engine and exhaust system may be hot.
Avoid possible burns, allow engine and exhaust
system to cool before working on the engine.
DANGER
Gasolineisflammable.Usecautionwhenstoring
or handling it. Do not smoke while filling the fuel
tank. Do not fill fuel tank while engine is running
or in an enclosed area. Always fill fuel tank out-
side and wipe up any spilled fuel before starting
the engine. Store fuel in a clean, safety--ap-
proved container and keep the cap in place. Use
gasoline for the engine only; not for any other
purpose.
To Next Page
Loading...
