Toro Greensmaster TriFlex 3400 - Grooming Reel

Greensmaster 3300/3400Groomer Page 9 -- 10
Grooming Reel (Forward Rotating Groomer Drive)
Figure 7
1. Lock nut (4 used)
2. Drive cover
3. Groomer drive belt
4. Drive pulley
5. Shoulder bolt (2 used)
6. Spring
7. RH drive plate assembly
8. Groomer shim
9. RH groomer arm assembly
10. Cap screw (2 used)
11. Bushing (2 used)
12. Spring washer (2 used)
13. Lock nut (2 used)
14. LH support plate
15. LH groomer arm assembly
16. Special washer (2 used)
17. Rear roller height shim
18. Socket head screw (4 used)
19. Driven pulley
20. HOC screw (2 used)
21. HOC nut (2 used)
22. Plow bolt (2 used)
23. Grooming reel assembly
24. Front roller assembly
25. RH cutting unit sideplate
26. LH cutting unit sideplate
27. O--ring
FRONT
RIGHT
Antiseize
Lubricant
100 ft--lb
(135 N--m)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
1
20
21
22
23
24
11
12
13
25
26
27
17 to 21 ft--lb
(24 to 28 N--m)
Remove the groom ing reel to replace individualblades,
to replace worn groomer components, to reverse the
bladesontheshaft(ifnotequippedwithcarbideblades)
or to replace the grooming shaft.
Removal (Fig. 7)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove thecutting unitfrom themachine andplace
cutting unit on a flat work area.
3. If equipped, remove rear roller brush from cutting
unit (seeRear Roller BrushRemoval in theService and
Repairs section of Chapter 8 -- DPA Cutting Units).
4. Remove groomer drive cover (item 2) and groomer
driveb elt(item3)fromgroomerdrive(seeGroomerBelt
Replacement in this section).