Toro Greensmaster TriFlex 3400 - Reel Assembly Removal and Installation

Greensmaster 3300/3400
DPA Cutting Units
Page 8 -- 20
Reel Assembly Removal and Installation
1. Crossmember
2. LH side plate
3. Washer head screw (2 used)
4. Shoulder bolt (2 used per side plate)
5. Flange nut (2 used per side plate)
6. Cutting reel assembly
7. Pitch arm (2 used)
8. Cap screw (2 used)
9. RH side plate
10. Weight
11. Hex nut (4 used)
12. O--ring
13. Grass shield
14. Flat wire spring
15. Crosslink
16. Reel motor adapter
17. Socket head screw (2 used)
18. Motor clamp
Figure 22
FRONT
RIGHT
Grease OD
210 to 240 in--lb
(24to27N--m)
4
2
9
5
13
1
4
5
5
5
7
15
3
7
11
3
8
210 to 240 in--lb
(24to27N--m)
10
12
surface
Grease OD
surface
6
14
16
18
11
17
NOTE: This section provides theprocedure for remov-
ingand installingthecutting reelassembly(cutting reel,
flockedseals,reelbearings,bearinglockscrewandreel
nut) from the cutting unit. Refer to Reel Assembly Ser-
vice later in this section for information on servicing the
cutting reel assembly.
NOTE: Removal of thecutting reel requires removal of
the L H side plate from the cutting unit crossmember.
TheRHsideplatedoesnothavetoberemovedfromthe
frame when using the following procedure.