Greensmaster 3300Page 3 -- 16Gasoline Engine
Engine Installation (Fig. 9)
1. Make sure that all removed engine components are
correctly installed to the engine.
2. If exhaust system components were removed from
engine, attach removed components using Figure 9 as
a guide.
3. Apply antiseizelubricant toenginecrankshaft. Posi-
tion square key (item 19) to crankshaft.
IMPORTANT: Make sure to not damage the engine,
fuel hose, hydraulic hoses, electrical harness, con-
trolcablesorotherpartswhile installingtheengine.
4. Aligntheenginehub(item20)withtheenginecrank-
shaft and square key.
5. While supporting the engine to prevent damaging
thepump coupling,carefully movethe engineso crank-
shaftslidesintotheenginehub(item20)andtowardthe
pump mount. Once the engine contacts the pump
mount,alignmountingholesandsecureenginetopump
mount with four (4) cap screws (item 13). Torque cap
screws from 25 to 38 ft--lb (34 to 51 N--m).
6. Make sure that rubber coupling (item 22) is not dis-
torted.Secureenginehubtoenginecrankshaftwithtwo
(2) square head screws (item 21). Torque screws from
90 to 110 in--lb (10.2 to 12.4 N--m).
7. Securewireharnessgroundconnectortoengineas-
sembly with cap screw (item 5), flat washer (item 26),
lock washer (item 25) and flange nut (item 6) (Fig. 11).
Make sure that lock washer is positioned between
ground connector and engine flange to ensure ground
connection to engine.
8. Connect all wire harness connectors to correct en-
gine components.
9. Connectandadjustthechokecontrolcable(seeAd-
justing the Choke Control in the Adjustments section of
this chapter).
10.Connect and adjust the throttle control cable (see
Adjusting the Throttle Control in the Adjustments sec-
tion of this chapter).
11.Connectfuel hoses to the fuel filter outlet and check
valve near rear engine cylinder head (Fig. 10). Secure
hoses with hose c lamps.
12.Openfueltankshut--offvalveandcheckfuelhosefor
leaks.
13.Check engine oil level and adjust if necessary.
14.Start the engine and check for proper operation.
To Next Page
Loading...
