Greensmaster 3300/3400
DPA Cutting Units
Page 8 -- 27
Reel Motor Adapter
Removal
1. Positionmachineonacleanandlevelsurface,lower
cuttingunits,stopengine,engageparkingbrakeandre-
move key from the ignition switch.
2. Removethehydraulicreelmotorfromthecuttingunit
(see Cutting Reel Motors in the Service and Repairs
section of Chapter 5 -- Hydraulic System). Move motor
tostoragelocationonfrontofcuttingunitsuspensionas-
sembly.
3. Remove reel motor adapter from cutting unit side
plate using Fig. 27 as a guide.
4. Remove O--rings as necessary from motor adapter
(Fig. 28).
Installation
1. If large O--ring was removed from flange of motor
adapter, lubricate O--ring with grease. Small O--rings
should be installed into motor adapter without lubrica-
tion. Make sure that O--rings are correctly positioned in
grooves in adapter.
2. Installreelmotoradaptertocuttingunitsideplateus-
ing Fig. 27 as a guide.
3. Secure hydraulic reel motor to the cutting unit (see
Cutting Reel Motors in the Service and Repairs section
of Chapter 5 -- Hydraulic System).
1. Hex nut
2. Reel motor adapter
3. Socket head screw
4. Motor clamp
Figure 27
2
4
3
1
1. Adapter
2. O--ring
3. O--ring
Figure 28
2
3
1
DPA Cutting
Units
To Next Page
Loading...
