Greensmaster 3400Page 4 -- 18Diesel Engine
Engine Bell Housing
Figure 17
1. Engine
2. Flange head screw (5 used)
3. Bell housing
4. Coupling flange
5. Flange head screw (5 used)
6. Dowel pin (2 used)
5
3
4
2
1
6
FRONT
RIGHT
Removal (Fig. 17)
NOTE: The hydraulic pump assembly needs to be re-
moved from engine before bell housing and coupling
flange can be r emoved.
1. Ifengineisinmachine,supportenginefrombelowto
preventitfromshifting.Removehydraulicpumpassem-
bly(see Piston(Traction)PumpRemovalinthe Service
and Repairs section of Chapter 4 -- Hydraulic System).
2. As necessary, remove bell housing and coupling
flange from engine using Figure 17 as a guide.
Installation (Fig. 17)
1. If coupling flange was removed from engine fly-
wheel, position flange to flywheel and align mounting
holes.Secureflangetoflywheelwithfive(5)flangehead
screws. Tighten screws in a star pattern.
2. Ifbellhousingwas removedfromengine,make sure
that spring pin is secure in upper hole of bell housing.
Position bell housing to flywheel plate and secure with
five(5)flangeheadscrews.Tightenscrewsinastarpat-
tern.
3. If engine is in machine, install hydraulic pump as-
sembly (see Piston (Traction) Pump Installation in the
Service and Repairs section of Chapter 5 -- H ydraulic
System).
To Next Page
Loading...
