Greensmaster 3300/3400 Page 7 -- 7 Chassis
Removal (Fig. 5)
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Chock wheels to prevent machine from shifting.
3. Loosen, but do not remove, lug nuts.
Whenchangingattachments,tiresorperforming
other service, use correct supports, hoists and
jacks. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
themachine.Alwayschockorblockwheels.Use
jackstandsorotherappropriateloadholdingde-
vices to support the raised machine. If the ma-
chine is not properly supported, the machine
may move or fall, which may result in personal
injury.
CAUTION
4. Using a jack, raise machine so wheel is off ground
(see Jacking Instructions in Chapter 1 -- Safety). Sup-
port machine with appropriate jack stands.
5. Remove lug nuts and then remove wheel from ma-
chine.
Installation (Fig. 5)
1. Install wheel and secure with four (4) lug nuts.
2. Lower machine to ground.
Failure to maintain proper wheel lug nut torque
couldresultinfailure orlossofwheeland mayre-
sult in personal injury.
WARNING
3. Torque lug nuts evenly in a crossing pattern from 65
to 85 ft--lb (89 to 115 N--m).
Chassis
To Next Page
Loading...
