Toro Greensmaster TriFlex 3400 - Page 241

Greensmaster 3300/3400 Page 7 -- 11 Chassis
Brake Cable Removal (Fig. 9)
1. Park machineon alevel surface,lower cuttingunits,
stop engine and remove key from the ignition switch.
Make sure that parking brake is not applied.
2. Chockfrontwheelstopreventmachinefrommoving.
3. Remove cover(s) (items 3 and 24) from machine to
allow access to brake cable that is to be removed.
4. Disconnect brake cable from brake actuator lever:
A. Remove e--ring (item 23) and clevis pin (item 7)
that secure brake cable clevis to brake actuator lev-
er.
B. At brake cable bracket, loosen upper cable jam
nut to allow slack in cable. Then remove lower jam
nut from threads on brake cable.
C. Separate brake cable from brake cable bracket
and brake actuator lever.
5. Disconnect brake cable from equalizer bracket at
brake lever:
A. Removee--ringthatsecuresbrakecabletoframe
bracket.
B. Remove cable end from equalizer bracket.
C. Separate brake cable from frame bracket.
6. Notelocation ofcable tiesandroutingofbrakecable
for assembly purposes. Remove brake cable from ma-
chine.
Brake Cable Installation (Fig. 9)
1. Usingnotestakenduringbrakecableremoval,route
brakecableontomachine.Makesurethatparkingbrake
is not applied.
2. Connectbrakecabletoequalizerbracketatbrakele-
ver:
A. Route brake cable end through hole in frame
bracket.
B. Connect cable end to equalizer bracket.
C. Securebrake cable toframe bracketwith e--ring.
3. Connect brake cable to brake actuator lever:
A. Position brake cable clevis to brake actuator le-
ver. Secure cable to actuator lever with clevis pin
(item 7) and e--ring (item 23).
B. Route end of brake cable through brake cable
bracket (item 19).
C. Install lower jam nut onto brake cable threads.
4. Secure brake cables to machine with cable ties in
locations noted during cable removal.
5. Adjust brake cables (see Parking Brake Adjustment
in the Adjustments s ection of this chapter).
6. Install cover(s) (items 3 and 24) to machine.
7. Afterbrakecableshavebeeninstalledandadjusted,
make sure to check operation of parking brake and
brake interlock system.
Chassis