Greensmaster 3300/3400 Page 7 -- 1 9 Chassis
Raise Tank Mount Plate Assembly
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Locate and remove four (4) screws that secure tank
mount plate to frame.
3. Carefully lift tank mount plate assembly (hydraulic
reservoir, fuel tank and tank mount plate) up from ma-
chine. Take care to not damage fuel lines, hydraulic
hoses or electrical components as assembly is raised.
Supportmount plateassembly inaraised positiontoal-
low access to machine components.
4. If additional clearance below the tank mount plate
assembly is desired, the suction hose can be clamped
and disconnected from the gear pump:
A. Clamp suction hose to prevent draining the hy-
draulic tank.
B. Thoroughly clean junction of suction hose and
gear pump inlet fitting.
C. Disconnectsuctionhosefromgearpump inletfit-
ting.
D. Carefully raise and support the tank mount plate
assembly.
5. After completing service work below the tank mount
plate assembly, carefully lower assembly to machine
frame.Secureassemblytoframewithremovedscrews.
Ifsuction hosewas disconnectedfromgearpump,con-
nect hose to pump fitting and secure with hose c lamp.
Remove Tank Mount Plate Assembly
1. Parkmachineonalevelsurface,engagetheparking
brake, lower the cutting units and stop the engine. Re-
move key from the ignition switch.
2. Completely drain hydraulic oil from hydraulic reser-
voirthroughgearpumpsuctionhoseintoasuitablecon-
tainer.
3. Disconnecthydraulichosesfromfittingsonhydraulic
tank. Put clean caps or plugs on hoses and fittings.
4. Close fuel shut off valve on fuel tank.
5. Disconnect additional fuel system hoses:
A. On Greensmaster 3300 machines, disconnect
hosesfromfuelfilterandcheckvalvethatarelocated
next to rear cylinder head (Fig. 16). Also, remove
cable tiethatsecures hose fromcarbon cannister to
rear frame tube under tank mount plate.
B. On Greensmaster 3400 machines, disconnect
fuel supply hosefrom shut offvalve on fuel tank and
fuelreturnhosefromhosesplicerfittingaboveradia-
tor. Also,removevent hose from grommetin engine
support.
6. If machine is equipped with the Turf Guardian
TM
Leak Detector System, disconnect wire harness con-
nectors from oil level sensor and solenoid c oil.
7. Removefour(4)screwsthatsecuretankmountplate
to frame.
8. Lift tank mount plate assembly (hydraulic reservoir,
fuel tank and tank mount plate) from machine.
9. After completing service work below the tank mount
plate assembly, install assembly to machine:
A. Carefully position tank mount plate assembly to
machine frame. Secure assembly to frame with re-
moved screws.
B. Connect andsecure allhydraulichoses (seeHy-
draulicHose andTubeInstallationin theGeneral In-
formation section ofChapter 5 -- Hydraulic System).
C. Connect and secure all fuel hoses. Open fuel
shut off valve on fuel tank.
D. If machine is equipped with the Turf Guardian
TM
Leak Detector System, connect w ire harness con-
nectors to oil level sensor and solenoid coil.
E. Fill hydraulic reservoir with new hydraulic oil.
Figure 16
1. Fuel filter
2. Check valve
3. Rear cylinder head
2
1
3
Chassis
To Next Page
Loading...
