Greensmaster 3300 Page 3 -- 9 Gasoline Engine
Removal (Fig. 3)
1. Parkmachineonalevelsurface,disengageandlow-
er cutting units, move functional control lever to neutral
(N),engageparking brake,stopthe engineandremove
the key from the ignition switch. Wait for all machine
movement to stop.
DANGER
Gasolineisflammable.Usecautionwhenstoring
or handling it. Do not smoke while filling the fuel
tank. Do not fill fuel tank while engine is running
or in an enclosed area. Always fill fuel tank out-
side and wipe up any spilled fuel before starting
the engine. Store fuel in a clean, safety--ap-
proved container and keep the cap in place. Use
gasoline for the engine only; not for any other
purpose.
2. Access thecarbon cannisterunder thefuel tankand
betweentherearframesections.Ifnecessary,raiseand
supporttankmountplateassembly(hydraulicreservoir,
fuel tank and tank mount plate) to reach the cannister
(seeTank MountPlateAssemblyin theServiceandRe-
pairs section of Chapter 7 -- Chassis).
3. Inspect carbon cannister and attached for damage
or obvious leaks. A damaged or leaking cannister
should be replaced.
4. Remove components as needed using Figure 3 as
a guide.
A. Ifcheckvalve(item15)isremoved,notedirection
of arrow on valve body for assembly purposes.
Installation (Fig. 3)
1. Install all removed components using Figure 3 as a
guide.
A. Ifcheckvalve (item15) wasremoved,makesure
that arrow on valve body points toward engine.
B. Make sure that fuel hoses are not kinked after
installation.Also,secureallhoseswithhoseclamps.
2. If tank mount plate assembly (hydraulic reservoir,
fueltankandtankmountplate)wasraisedtoaccessthe
cannister, lowerand secure tankmountplate assembly
(seeTank MountPlateAssemblyin theServiceandRe-
pairs section of Chapter 7 -- Chassis).
Figure 4
1. Carbon cannister
2. Hose to tank vent
3. Hose to engine
3
2
1
FRONT
Gasoline
Engine
To Next Page
Loading...
