Toro ProLine H800 - Traction Reverse Switch

TractionReverseSwitch
g294810
Figure128
1.Reverseswitch
ThereverseswitchsendssignalstotheElectronicControlUnit(ECU)about
thetractionpedalposition.TheECUtakestheinputsfromreverseswitchand
activatesthewarningbuzzer.
Thereverseswitchislocatedundertheoperator’splatform.
TestingtheTractionReverseSwitch
1.Parkthemachineonalevelsurface,lowerthecuttingdeck,andshutoff
theengine.
2.Locateanddisconnecttheswitchconnectorfromthemachinewireharness
(Figure128).
3.Connectamultimeter(ohmssetting)acrosstheswitchconnectorterminals
tocheckthecontinuityoftheswitchasfollows:
A.Whentheswitchplungerisextended,thereshouldbecontinuitybetween
theswitchterminals.
B.Whentheswitchplungerispressed,thereshouldnotbecontinuity
betweentheswitchterminals.
4.Replacetheswitchiftestingdeterminesthattheswitchisdamaged.
5.Ifthereverseswitchtestingiscorrectandacircuitproblemstillexists,check
themainwireharness;refertotheElectricalSchematicsandWireHarness
Drawings/DiagramsinAppendixA(pageA–1).
6.Afteryoucompletethereverseswitchtesting,connecttheswitchconnector
tothemachinewireharness.
ProLineH800
Page6–31
ElectricalSystem:TestingtheElectricalComponents
19241SLRevB