Toro ProLine H800 - Service and Repairs; Hopper Assembly

ServiceandRepairs
HopperAssembly
g291254
Figure171
1.Bolt5.Washer9.Bolt
2.Washer6.Flangebushing10.Nut
3.Pin7.Nut
4.Bolt8.Hydrauliccylinder
RemovingtheHopperAssembly
1.Parkthemachineonalevelsurface,lowerthecuttingdeck,shutoffthe
engine,settheparkingbrakeandremovethekeyfromthekeyswitch.
2.Disconnectthehoppermicroswitchconnectorfromthemachinewire
harness.
3.Supportthehydraulicactuators(8)beforelooseningthemountingfasteners.
4.Removethenut(10)andbolt(9)thatsecuresthehydrauliccylindertothe
hopperassembly.
ProLineH800
Page9–3
HopperAssembly:ServiceandRepairs
19241SLRevB