Toro ProLine H800 - Lift Cylinder

LiftCylinder
g293858
Figure86
1.Pin6.Nut11.Washer
2.Greasetting7.Liftcylinder
12.Pin
3.Support
8.Breathercap
13.LHliftarm
4.Washer9.Washer
5.Nut10.Nut
RemovingtheLiftCylinder
1.Parkthemachineonalevelsurface,lowerthecuttingdeck,shutoffthe
engine,settheparkingbrake,andremovethekeyfromthekeyswitch.
2.ReadtheGeneralPrecautionsforRemovingandInstallingtheHydraulic
SystemComponents(page5–63).
3.Forassemblypurposes,labelallthehydraulicconnections.Cleanthe
hydraulicconnectionsbeforelooseningthehydrauliclinesfromthelift
cylinder.
CAUTION
Beforeopeningthehydraulicsystem,operateallthehydraulic
controlstoreleasesystempressureandavoidinjuryfromthe
pressurizedhydraulicuid;refertoReleasingPressurefromthe
HydraulicSystem(page5–5).
ProLineH800
Page5–109
HydraulicSystem:ServiceandRepairs
19241SLRevB