Toro ProLine H800 - Auxiliary Control Valve

AuxiliaryControlValve
g293274
Figure67
1.Knob8.Auxiliaryvalvelever15.Washer
2.Nut9.Bolt16.Nut
3.Spring
10.Washer17.Bandclamp
4.Pullerknob11.Auxiliaryvalvelever18.Bandclamp
5.Spring
12.Auxiliarycontrolvalve
19.Washer
6.Auxiliaryvalvelever13.Auxiliarycontrolvalvesupport
7.Connector
14.Bolt
RemovetheAuxiliaryControlValve
1.Parkthemachineonalevelsurface,lowerthecuttingdeck,shutoffthe
engine,settheparkingbrake,andremovethekeyfromthekeyswitch.
2.Drainthehydraulicuidfromthetankintoasuitablecontainer;referto
Operator’sManual.
3.Removetherightconsoletogetaccesstoauxiliarycontrolvalve;referto
DisassemblingtheBodyAssembly(page7–6).
4.Cleanthehydraulichoseendsandttingsonthehydraulictanktoprevent
contaminantsfromenteringintothehydraulicsystem.
5.Forassemblypurposes,labelallthehydraulichosesandttings.
HydraulicSystem:ServiceandRepairs
Page5–78
ProLineH800
19241SLRevB