Toro ProLine H800 - Page 147

RemovetheAuxiliaryControlValve(continued)
g293275
Figure68
1.Adaptor7.Bolt
2.Bolt
8.O-ring
3.Hose
9.O-ring
4.Fittingnipple10.Auxiliarycontrolvalve
5.Hose11.Hose
6.Fittingnipple
6.Removethehydraulicconnectionsfromtheauxiliarycontrolvalveand
discardtheO-ringsfromthettings(Figure68).
7.Installthecleancapsorplugsonthehydraulichosesandttingstoprevent
systemcontamination.
8.Removethebolts(item9inFigure67),washers(10and19)andnuts(16)
thatsecurestheauxiliarycontrolvalve(12)totheauxiliarycontrolvalve
support(13).
9.Removetheauxiliarycontrolvalvefromtheauxiliarycontrolvalvesupport.
10.Ifthehydraulicttingstoberemovedfromtheauxiliarycontrolvalve,mark
thettingorientationforassemblypurposes.Removethettingfromthe
auxiliarycontrolvalveanddiscardtheO-ringsfromthettings.
InstallingtheAuxiliaryControlValve
1.Ifthehydraulicttingswereremovedfromtheauxiliarycontrolvalve,
lubricateandinstallthenewO-ringstothettings.T oproperlyalignand
installthettingsintotheauxiliarycontrolvalveopenings,usethemarksthat
youmadeduringtheremovalprocess.Tightenthettings;refertoInstalling
theHydraulicFittings(page5–10).
2.Positiontheauxiliarycontrolvalveontotheauxiliarycontrolvalvesupport
andsecurewiththebolts,washersandnuts(Figure67).
3.Removethecapsorplugsthatwereinstalledtothehydraulichosesand
ttingsduringtheremovalprocess.
4.Usethelabelsthatyouattachedduringtankremovaltocorrectlyconnectthe
hydraulichosestothettingsontheauxiliarycontrolvalve;refertoInstalling
theHydraulicHosesandTubes(page5–8).
5.Fillthehydraulictankwiththecorrectquantityofnewhydraulicuid;refer
toOperator’sManual.
ProLineH800
Page5–79
HydraulicSystem:ServiceandRepairs
19241SLRevB