Toro ProLine H800 - Slope Sensor (Optional)

SlopeSensor(Optional)
g365064
Figure138
1.Slopesensormodule3.Flangenut(2each)
2.Capscrew(2each)
Theoptionalslopesensormoduleislocatedunderthebatterycover.Once
installedandcalibrated,theoptionalslopesensormodulemonitorstheangleof
themachineduringoperation,andnotiestheoperatorofapotentiallydangerous
conditionviaanLEDlightonthedashboardandanaudiblealarm.Switched
andunswitchedpowerfortheslopesensorisprovidedthroughthemachine
expansionport.Inadditiontothe30Ampfuseinthefuseblockprotectingthe
unswitchedpowersupplytotheexpansionport,anadditional2Ampfuseis
includedintheslopesensorwireharnesstoprotecttheslopesensormodule.
Theslopesensormodulecannotbetesteddirectly.
CalibratingtheSlopeSensor
1.Parkthemachineonalevelsurface,lowerthecuttingunitsandsetthekey
switchtotheOFFposition.
2.Removethebatterycover.
3.Removetheplugfromthecalibrationconnectorsandconnectthecalibration
connectorstogetherasshown;refertoFigure139.
ElectricalSystem:TestingtheElectricalComponents
Page6–44
ProLineH800
19241SLRevB