Toro ProLine H800 - Page 245

CalibratingtheSlopeSensor(continued)
g364991
Figure139
1.Plug
2.Calibrationconnectors
4.SetthekeyswitchtotheONposition,butdonotstarttheengine.
5.TheLEDlightonthedashboardshouldblinkasthesensorcalibrates.
6.WhentheLEDlightonthedashboardstopsblinking,setthekeyswitchto
theOFFposition.
7.Disconnectthecalibrationconnectorsandinstalltheplugontothe
connectors.
8.Carefullytesttheslopesensoroperationbeforereturningthemachineto
service:
A.SetthekeyswitchtotheSTARTposition.TheLEDlightonthedashboard
shouldilluminatefor5secondstoindicatethatthesensorisfunctioning
properly.
B.Duringmachineoperation,thelightandalarmindicatestheseverityof
theslope:
•Nolight–normaloperatingconditions.
•Slow,ashinglight–moderateslop(approximately11to14°).
•Fast,ashinglightandaudiblealarm–steepslope(approximately15°
ormore);proceedtoamoreshallowslope.
RemovingandInstallingtheSlopeSensorModule
RefertoFigure138forthisprocedure.
1.Parkthemachineonalevelsurface,lowerthecuttingunits,setthekey
switchtotheOFFpositionandremovethekeyfromthekeyswitch.
2.Removethebatterycover.
3.Disconnectthewireharnessfromtheslopesensormodule.
4.Checktheharnessconnectorandsensormodulefordamageorcorrosion
andcleanorrepairifnecessary.
5.Removetheslopesensormodulefromthemachine.
ProLineH800
Page6–45
ElectricalSystem:TestingtheElectricalComponents
19241SLRevB