Toro ProLine H800 - Page 178

RemovingtheLiftCylinder(continued)
WARNING
Ensurethatthecuttingdeckisfullyloweredbeforelooseningthe
hydrauliclinesfromtheliftcylinders.
Ifthecuttingdeckisnotfullyloweredasthehydrauliclinesare
loosened,thecuttingdeckmaydropunexpectedly.
g293859
Figure87
1.Auxiliarycontrolvalve
6.O-ring
2.O-ring
7.Bolt
3.Liftcylinder
8.Bolt
4.Hose9.Breathercap
5.Hose
4.Disconnectthehydraulichosesfromthettingsintheliftcylinderthatistobe
removed.Allowthehosestodrainintoasuitablecontainer.Removeand
discardtheO-ringsfromthettings.
5.Installcleancapsorplugsonthehydraulichosesandttingstoprevent
contamination.
6.Removethenut(item5inFigure86),washer(4)andpin(1)thatsecures
theliftcylindertotheliftarm.
7.Removethenut(10),washers(9and11)andpin(12)thatsecuresthelift
cylindertothechassis.
8.Removetheliftcylinderfromthemachine.
9.Ifthehydraulicttingsaretoberemovedfromtheliftcylinder,markthetting
orientationforassemblypurposes.Removethettingsfromtheliftcylinder
anddiscardtheO-ringsfromthettings.
HydraulicSystem:ServiceandRepairs
Page5–110
ProLineH800
19241SLRevB