Toro ProLine H800 - Page 313

DisassemblingtheHopper
1.Parkthemachineonalevelsurface,lowerthecuttingdeck,shutoffthe
engine,settheparkingbrakeandremovethekeyfromthekeyswitch.
2.Removethehopperassemblyfromthemachine;refertoRemovingthe
HopperAssembly(page9–3).
3.DisassemblethehopperusingtheFigure174asaguide.
4.Notethelocationoftheelectricalconnectorsforassemblypurposes.
AssemblingtheHopper
1.AssemblethehopperusingtheFigure174asaguide.
2.Connecttheelectricalconnectorsasnotedduringthedisassembly.
3.Installthehopperassemblyontothemachineframe;refertoInstallingthe
HopperAssembly(page9–4).
4.Checkandalignthehopperassemblytothechuteseal;refertoOperator’s
Manual.
5.Lubricatethegreasettings;refertoOperator’sManual.
6.Checkforcorrectoperationofthehopperassemblyandadjustthehopper
assemblysensor;refertoOperator’sManual.
ProLineH800
Page9–9
HopperAssembly:ServiceandRepairs
19241SLRevB