Toro reelmaster 5410 series - Page 133

InstallinganAdjustableFitting(continued)
3.LightlylubricatetheO-ringwithcleanhydraulicuid.Ensurethatthethreads
ofthettingarecleanwithnolubricantapplied(Figure61).
g221225
Figure62
4.Turnbackthelocknutasfaraspossible.Ensurethattheback-upwasheris
notlooseanditispushedupasfaraspossible(Step1inFigure62).
IMPORTANT
Beforeinstallingthettingintotheport,determinethematerialof
whichtheportismade.Installingattingintoanaluminumport
requiresareducedinstallationtorque.
5.Installtheadjustablettingintotheportbyhanduntilthewashercontactsthe
faceoftheport(Step2inFigure62).
6.Iftheadjustablettingneedstoalignwithanothercomponent,rotatethetting
counterclockwiseuntilitisalignedtothedesiredposition(Step3inFigure
62).Donotrotatetheadjustablettingmorethan1turncounterclockwise.
7.Holdthettinginthecorrectalignmentwithawrenchanduseatorque
wrenchandtightenthettingtotherecommendedtorquevaluewithinthe
speciedrangeoftorquevalues;refertotheFittingInstallationT orqueTable
(page6–13).Thistighteningprocedurerequiresadrive-adapterwrench
(e.g.,crowfootwrench).
Note:Itmaybenecessarytouseadrive-adapterwrench(e.g.,crowfoot
wrench)toinstallahydraulictting;refertoCalculatingtheT orqueValues
WhenUsingaDrive-AdapterWrench(page2–6).
8.Ifatorquewrenchisnotavailableorifspaceattheportpreventstheuse
ofatorquewrench,usethealternativeprocedureFlatFromFingerTight
Table(page6–14)givenbelow;
A.Holdthettinginthecorrectalignmentwithawrenchand,iftheport
materialissteel,tightenthelocknutwithasecondwrenchtothelisted
FFFT(Step4inFigure62).
B.Iftheportmaterialisaluminum,tightenthettingto60%ofthelisted
FFFT;refertotheFlatFromFingerTightT able(page6–14).
Reelmaster
®
5410/5510/5610Series
Page6–15
HydraulicSystem:GeneralInformation
15216SLRevC