Toro reelmaster 5410 series - Page 184

TestProcedure(continued)
CAUTION
Beforeopeninghydraulicsystem,operateallhydrauliccontrolsto
relievesystempressureandavoidinjuryfrompressurizedhydraulic
uid;refertoReleasingPressurefromtheHydraulicSystem(page
6–8).
3.Raiseandpropoperatorseattoallowaccesstohydraulicpumpassembly.
g230038
Figure88
1.Piston(traction)pump3.Oillter/lteradapter
5.Hydraulictube
2.Pistonpumpinlettting4.Filterinlettting
6.Hydraulictube
4.Cleantheendsofthehydraulictubesconnectedtothepistonpumpandoil
lterinlets(Figure88).Disconnecthydraulictubesfrompistonpumpandoil
lterinletttings.Remove2ange-headscrewsthatsecureoillteradapter
toframe.Removeoillterassemblywithhydraulictubefrommachine.
IMPORTANT
Ensurethattheuidowindicatorarrowontheowmeteris
showingthattheuidwillowfromthehydraulictube,throughthe
testerandintothepiston(traction)pump.
5.Installtesterwithpressuregaugeandowmeterinplaceoftheremovedoil
lterassemblyandhydraulictube(Figure88).Connecttesterinlethoseto
thehydraulictube.Connectthetesteroutlethosetothepiston(traction)
pumpinlettting.Ensurethattheowcontrolvalveontesterisfullyopen.
6.Ensurethatthetractionpedalisinneutral,thesteeringwheelisstationary,
andtheparkingbrakeisengaged.
7.Startengineandrunatidlespeed.Checkforanyhydraulicleakagefromtest
connectionsandcorrectbeforeproceedingwithtest.
8.Ensurethatthehydraulicuidisatnormaloperatingtemperatureby
operatingthemachineunderloadforapproximately10minutes.
HydraulicSystem:TestingtheHydraulicSystem
Page6–66
Reelmaster
®
5410/5510/5610Series
15216SLRevC