Toro reelmaster 5410 series - Page 215

TestProcedure(continued)
CAUTION
Beforeopeninghydraulicsystem,operateallhydrauliccontrolsto
relievesystempressureandavoidinjuryfrompressurizedhydraulic
uid;refertoReleasingPressurefromtheHydraulicSystem(page
6–8).
g230050
Figure110
1.Steeringcylinder2.Rodendtting
3.Cleantheareaaroundthehydraulichoseandttingattherodendofthe
steeringcylinder(Figure110).
4.Removehydraulichosefromthettingontherodendofthesteeringcylinder.
5.Installateettingbetweenthedisconnectedhydraulichoseandthesteering
cylindertting.Installa34,500kPa(5,000psi)pressuregaugetothetee
tting.
6.Afterinstallingpressuregauge,startengine,andrunatidlespeed.Checkfor
anyhydraulicleakagefromtestconnectionsandcorrectbeforeproceeding
withtest.
7.Ensurethatthehydraulicuidisatnormaloperatingtemperatureby
operatingthemachineunderloadforapproximately10minutes.
8.Ensurethattheengineisrunningathighidlespeed.
IMPORTANT
Holdsteeringwheelatfulllockonlylongenoughtogetasystem
pressurereading.Holdingthesteeringwheelagainstthestopforan
extendedperiodmaydamagethesteeringcontrolvalve.
IMPORTANT
Assteeringwheelisturned,ensurethatthepressuregaugeisnot
contactedbyanymachineparts.
Reelmaster
®
5410/5510/5610Series
Page6–97
HydraulicSystem:TestingtheHydraulicSystem
15216SLRevC