Toro reelmaster 5410 series - Page 252

TestProcedure(continued)
CAUTION
Beforeopeningthehydraulicsystem,operateallthehydraulic
controlstoreleasesystempressureandavoidinjuryfromthe
pressurizedhydraulicuid;refertoReleasingPressurefromthe
HydraulicSystem(page6–8).
g217941
Figure135
1.Gearpump(P3)
2.Hydraulictube
3.Liftandsupporttheoperatorseattogetaccesstothehydraulicpump
assembly.
4.Cleanboththeendsofthehydraulictubethatconnectschargelteroutlet
withthetractionpump(Figure135).Disconnectbothendsofthehydraulic
tubeandremoveitfromthemachine.Plugbothendsoftheremoved
hydraulictubetopreventsystemcontamination.
IMPORTANT
Ensurethattheuidowindicatorarrowontheowmeteris
showingthattheuidwillowfromthehydraulictube,throughthe
tester,andintothetractionpump.
5.Installatesterwiththepressuregaugeandowmeterinplaceofthe
removedhydraulictube.Connectthetesterinlethosetothechargelter
ttingandoutlethosetothetractionpumptting.Ensurethattheowcontrol
valveonthetesterisfullyopen.
6.Ensurethatthehydraulicuidisatnormaloperatingtemperatureby
operatingthemachineforatleast10minutes.
7.EnsurethatthetractionpedalisintheNEUTRALposition,steeringwheelis
stationary,andparkingbrakeisset.
8.Starttheengineandrunitatlow-idlespeed(1,175to1,225rpm).Checkfor
hydraulic-uidleaksfromthetestconnectionsandcorrectbeforecontinuing
thetest.
HydraulicSystem:TestingtheHydraulicSystem
Page6–134
Reelmaster
®
5410/5510/5610Series
15216SLRevC