Toro reelmaster 5410 series - Page 544

CheckingtheReelBearingAdjustment(continued)
4.Useasuitabletorquewrenchandsplineinserttool(referto(page)),measure
therollingresistanceofthecuttingreel.Thecuttingreelrollingtorqueshould
notexceed1.1N∙m(10in-lb).
5.Ifreelhasend-playorifrollingtorqueisincorrect,performthereelbearing
adjustment;refertoAdjustingtheReelBearing(page9–14).
6.Aftercheckingoradjustingthereelbearings,adjustthecuttingunit;referto
theCuttingUnitOperator’sManual.
7.Installthehydraulicreelmotortothecuttingunit;refertoInstallingthe
HydraulicReelMotor(page9–17).
AdjustingtheReelBearing
g214493
Figure324
1.LHsideplate3.Bearingadjusternut
2.Threadedinsert
4.Setscrew
1.Ensurethatthereisnocontactbetweenthebedknifeandthereel.
2.RemovethecuttingunitcomponentsontheLHsideplatetogetaccess
tothebearingadjusternut.Ifthecuttingunitisequippedwitharearroller
brush;refertotheRearRollerBrush–Optional(cuttingunitswithpainted
sideplates)(page9–51).Ifthecuttingunitisequippedwithagroomer;refer
totheGroomerchaptersinthismanual.
3.LoosenthesetscrewthatsecuresthebearingadjusternutintheLHside
plateofthecuttingunit.
IMPORTANT
Overtighteningthereelbearingadjusternutmaydamagethereel
bearings.
4.Withthecuttingunitandreelinahorizontalposition,usea13/8inchsocket
andtorquewrenchtoovertightenthebearingadjusternutto4.5to5.1N∙m
(40to45in-lb).
5.Loosenthebearingadjusternutandthentorquethebearingadjusternut
to1.7to1.9N∙m(15to17in-lb).
CuttingUnit:Adjustments
Page9–14
Reelmaster
®
5410/5510/5610Series
15216SLRevC