Toro reelmaster 5410 series - Page 605

DisassemblingtheGroomerPlateAssembly(continued)
Note:Cuttingunitswithcastironsideplates(Figure376)useagroomer
driveshaftthatissecuredtothepivothubassemblyandisdrivenbythe
splinedinsertincuttingreel.Cuttingunitswithaluminumsideplates
useagroomerdriveshaftthatthreadsintothecuttingreelshaftsothat
thedriveshaftwillremainattachedtothereelshaftwhenthepivothub
isremoved.
H.Removethepivothubandidlerplateassemblyfromthecuttingunit.
I.Supportthegroomershafttopreventitfromfalling.Carefullyslidethe
drivesidegroomerplatefromthegroomershaftandcuttingunit.Remove
thegroomershim.
3.Removethegroomerplateassemblyfromthegroomernon-drivesideof
thecuttingunitasfollows:
A.Removethehydraulicreelmotorfromthecuttingunit;refertoHydraulic
ReelMotor(page9–17).
B.Removethe2socket-headscrews(item2inFigure376)thatsecurethe
groomercomponentstothecuttingunitsideplate.
C.Removethepivothubfromthecuttingunit.
D.Supportthegroomershafttopreventitfromfalling.Carefullyslidethe
non-drivesidegroomerplatefromthegroomershaftandcuttingunit.
g215603
Figure378
Drivesidegroomerplate
1.Groomerplate
3.Bushing
5.Greasetting
2.Groomerstud(2each)4.Seal(3each)
6.Bearing
Reelmaster
®
5410/5510/5610Series
Page10–11
BeltDrivenGroomer(Optional):ServiceandRepairs
15216SLRevC