Toshiba B-EP Series - 5.6.11 TWO-DIMENSIONAL CODE FORMAT COMMAND (MaxiCode)

CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-136
5.6.11 TWO-DIMENSIONAL CODE FORMAT COMMAND (MaxiCode) [ESC] XB
Format c [ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) (= mmm ------ mmm) [LF] [NUL]
d [ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) (; nn
1,
nn
2,
nn
3,
------ , nn
20
) [LF] [NUL]
Term aa: Two-dimensional code number
00 to 31
bbbb: X-coordinate of the print origin of the two-dimensional code
Fixed at 4 digits (in 0.1 mm units)
cccc: Y-coordinate of the print origin of the two-dimensional code
4 or 5 digits (in 0.1 mm units)
d: Type of two-dimensional code
Z: MaxiCode
e: Mode selection (Omissible)
• When the MaxiCode specification is set to “TYPE1: Compatible with the
current version” in the SYSTEM mode.
Omitted: Mode 2
0: Mode 2
1: Mode 4
2: Mode 2
3: Mode 3
4: Mode 4
5: Mode 2
6: Mode 6
7: Mode 2
8: Mode 2
9: Mode 2
• When the MaxiCode specification is set to “TYPE2: Special specification” in
the SYSTEM mode.
Omitted: Mode 2 or Mode 3(*)
0: Mode 2 or Mode 3(*)
1: Mode 4
2: Mode 2
3: Mode 3
4: Mode 4
5: Mode 2 or Mode 3 (*)
6: Mode 6
7: Mode 2 or Mode 3 (*)
8: Mode 2 or Mode 3 (*)
9: Mode 2 or Mode 3 (*)
*: Mode 2 or Mode 3 should be determined depending on the country
code of the data command. When the country code is 840, Mode 2
should be selected. For other codes than 840, Mode 3 should be
selected.
Jffgg: Connection setting (Omissible. If omitted, connection is not made.)
ff: Code number 01 to 08
gg: No. of divided codes 01 to 08