CHAPTER 10 SYSTEM MODE (INTERFACE COMMANDS)
B-EP Series
10-25
10.10.2 BLUETOOTH DEVICE NICKNAME SETTING [ESC] BN
Function Sets Bluetooth device nickname.
Format [ESC] BN; aaa…aaa [LF] [NUL]
Term aaa…aaa: Device nickname
B-EP-GH30/TH30: Up to 32 bytes
B-EP-GH32: Up to 24 bytes
Factory default: “TOSHIBATEC BT”
Explanation (1) Printer device nickname to be notified to the host is set.
(2) The device nickname set by this command becomes effective when the printer is
restarted after a proper power off of the printer.
(3) In the LABEL mode (Mode = 0), RECEIPT mode (Mode = 1) or RECEIPT1 mode
(Mode = 2), the printer returns “38H” (setting completed) when the processing for
the Bluetooth module is completed successfully, and returns “39H” (setting error)
when failed. In the TPCL mode (Mode = A) or TPCL1 mode (Mode = B), the
printer returns “38” (setting completed) when the setting for the Bluetooth module
is completed, and returns “39” (setting error) when failed.
(4) Characters of 20H to 7FH can be used for a device nickname. For the B-EP-GH32,
only the alphanumerals and spaces are accepted.
(5) Up to 24-byte device nickname can be set for the B-EP-GH32. Setting 25 bytes or
more results in a syntax error.
Example To set “PRINTER” for a device nickname.
[ESC] BN; PRINTER [LF] [NUL]
To Next Page
Loading...
Need help?
General