CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-26
8.10.14 MINIMUM DOTS FOR LINE FEED LENGTH SET COMMAND [ESC] 3
Function Sets a line feed length to n/2 dot.
Specifies the minimum number of dots for line feed.
Format [ESC] 3n
Term ASCII: ESC 3
Hex: 1Bh 33h
[Parameter]
n: Line feed length (n/2 dot) 0 ≤ n ≤ 255 (00h ≤ n ≤ FFh)
Default value n: 60 (Line feed length of 30 dots)
Explanation (1) Line feed lengths can be independently specified in standard and page modes.
(2) Fractions are rounded up.
(3) The minimum permissible value is 00h for a line feed length. However, a line feed
length is only applicable when a value of 60 (30 dots) or over is specified. If a
value less than 60 is specified, a line feed length will be changed to 30 dots.
Reference 30-dot Line Feed Length Set Command ([ESC] 2)
To Next Page
Loading...
Need help?
General