Toshiba B-EP Series - 6.4 COMMANDS RELATED TO FINE ADJUSTMENT; 6.4.1 PRINT START POSITION FINE ADJUST COMMAND

CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
B-EP Series
6-11
6.4 COMMANDS RELATED TO FINE ADJUSTMENT
6.4.1 PRINT START POSITION FINE ADJUST COMMAND [ESC] AX
Function Adjusts the feed value so that the label will be shifted forward or backward from the
standard print start position.
Format [ESC] AX; abbb(, cddd, eff) [LF] [NUL]
[In compatible mode for the B-SP series]
[ESC] AX; abbb(, cddd, eff) [LF] [NUL]
Term a: Indicates the direction, forward or backward, in which a fine adjustment is to
be made.
+: Backward
-: Forward
bbb: Fine adjustment value for print position
000 to 500 (in 0.1 mm units)
c: Indicates the direction of the strip position, forward or backward.
+: Backward
-: Forward
ddd: Fine adjustment value for strip position (Omissible)
000 to 030 (in 0.1 mm units)
* Fine adjustment in - (forward) direction is made between 000 and 020.
eff: Reserved area (Omissible)
Omitted or +20 (Fixed)
* If omitted, print is started at 5 mm from the leading edge of the label.
* If set to +20, print is started at 3 mm from the leading edge of the label.
[In compatible mode for the B-SP series]
a: Indicates the direction, forward or backward, in which a fine adjustment is to
be made.
+: Backward
-: Forward
bbb: Fine adjustment value for print position
000 to 500 (in 0.1 mm units)
cddd: Indicates that back feed amount is finely adjusted backward. (Omissible)
+000 (Fixed)
eff: Indicates that back feed amount is finely adjusted forward. (Omissible)
+20 (Fixed)
* When the omissible parameters (,cddd and ,eff) are omitted, print is started at 5 mm
from the leading edge of the label.
When the omissible parameters (,cddd and ,eff) are set, print is started at 3 mm from
the leading edge of the label.