CHAPTER 8 ESC/POS MODE (INTERFACE COMMANDS)
B-EP Series
8-84
8.11 TEC ORIGINAL COMMANDS
8.11.1 MODE SELECT COMMAND [ESC] M
Function Changes the print mode.
Format [ESC] M; a (,b) [LF] [NUL]
Term a: Print mode designation
76 5 4 3210
* Table 1 Print mode
HEX Mode
How to deal with the received data after an error is cleared
30H LABEL Discards
31H RECEIPT Discards
32H RECEIPT1 Continues printing
34H ESC/POS Continues printing
41H TPCL Continues printing
42H TPCL1 Continues printing
b: Print position detection feed (Omissible. If omitted, the print position detection
feed is not performed.)
0: When the mode change from RECEIPT, RECEIPT1 or ESC/POS to LABEL,
TPCL or TPCL1 is requested, a print position detection feed is not performed
after the mode is changed.
1: When the mode change from RECEIPT, RECEIPT1 or ESC/POS to LABEL,
TPCL or TPCL1 is requested, a print position detection feed is performed after
the mode is changed.
Print mode (Bit 0 to Bit 6 * See Table 1.)
Automatic status response in IrDA: IrCOMM or USB
0: Not performed
1: Performed
To Next Page
Loading...
