Toshiba B-EP Series - 6.5.8 BARCODE FORMAT COMMAND (CUSTOMER BARCODE)

CHAPTER 6 LABEL MODE (INTERFACE COMMANDS)
B-EP Series
6-40
6.5.8 BARCODE FORMAT COMMAND
(CUSTOMER BARCODE) [ESC] XB
Function Sets the format to indicate the position on the label, at which the barcode is to be
printed and how it is to be printed.
Format [ESC] XBaa; bbbb, cccc, d, e, ff, g, hhhh, iii, j, kk, l, m [LF] [NUL]
Term aa: Barcode No.
00 to 99
(The same No. must not be used in one form for the bit map font field, the
outline font field, and the barcode field.)
bbbb: Print origin of X-coordinate of barcode
Fixed at 4 digits (in 0.1 mm units)
cccc: Print origin of Y-coordinate of barcode
Fixed at 4 digits (in 0.1 mm units)
d: Type of barcode
R: Customer barcode (Postal code for Japan)
S: Highest priority customer barcode (Postal code for Japan)
e: Type of check digit
3 (Fixed value): Check digit auto attachment
ff: 1-module width
01 to 15 (in units of dots)
g: Rotational angle of barcode
0: 0°
1: 90°
2: 180°
3: 270°
hhhh: Height of long bars
0001 to 0350 (in 0.1 mm units)
iii: Reserved area
000 (Fixed value)
j: Reserved area
0 (Fixed value)
kk: Data length
00 to 20: Customer barcode
00 to 19: Highest priority customer barcode
NOTE: When “00” is designated, the length is equivalent to the data sent
by the Data Print Command Data which is delimited by [LF])
l: Data code
1 (Fixed value): JIS8 code
m: Fixed data No.
0 (Fixed value)