Toshiba B-EP Series - 3.2.9 HANDLING OF RECEIVED DATA WHEN THE PRINTER GOES INTO POWER SAVE MODE

CHAPTER 3 INTERFACE
B-EP Series
3-40
3.2.9 HANDLING OF RECEIVED DATA WHEN THE PRINTER GOES INTO POWER SAVE MODE
When data is divided into multiple blocks in IrDA: TEC Protocol and received, the printer discards
previously received data and goes into a wait state to receive data from the first block if reception
is stopped and a timeout occurs (power save mode).
During single block, the printer discards partially received data and goes into a wait state to
receive data from the first "STX" if reception is stopped and a timeout occurs (power save mode),
because the reception mode changes to the "STX reception wait state."