CHAPTER 5 TPCL-LE MODE (INTERFACE COMMANDS)
B-EP Series
5-203
Notes
(1) The status is returned only to the interface which sent this command.
(2) The printer returns the same status, regardless of whether or not the compatible mode for
the B-SP series is set.
(3) After the code of the Bit Map Writable Character Command ([ESC] XD) or Graphic
Command ([ESC] SG) is received, the Status Request Command is not processed until
the printer receives the data specified for the type of data.
(4) After receiving the Status Request Command, there may be a maximum of 20-msec.
delay until the printer sends a status.
(5) At least, a 20-msec. interval must be given between the transmissions of the Status
Request Command. If the next Status Request Command is transmitted within 20
msec., the printer may fail to receive it.
Example [ESC] WB [LF] [NUL]
To Next Page
Loading...
