CHAPTER 7 RECEIPT MODE (INTERFACE COMMANDS)
B-EP Series
7-47
Notes (1) The status is returned only to the interface which sent this command.
(2) The printer returns the same status, regardless of whether or not the compatible
mode for the B-SP series is set.
(3) After the code of the Bit Map Writable Character Command ([ESC] XD) or Graphic
Command ([ESC] SG) is received, the Status Request Command is not processed
until the printer receives the data specified for the type of data.
(4) After receiving the Status Request Command, there may be a maximum of 20-
msec. delay until the printer sends a status.
(5) At least, a 20-msec. interval must be given between the transmissions of the
Status Request Command. If the next Status Request Command is transmitted
within 20 msec., the printer may fail to receive it.
Example [ESC] WB [LF] [NUL]
To Next Page
Loading...
